Fix code P0106 Manifold Absolute Pressure sensor
P0106 refers to a circuit or range performance problem
The Manifold Absolute Pressure sensor/Barometric Pressure Sensor (MAP/BARO)is a “speed density” method of determining the air fuel ratio. The sensor measures intake manifold vacuum, which varies depending on how wide open the throttle is. However, while the pistons are pulling a vacuum on the down-stroke, outside barometric pressure is also pushing air into the cylinder. So the sensor actually takes two readings—one before the engine starts (barometer pressure) and one after the engine starts. Once the engine is running, the computer constantly monitors the changing voltage from the MAP to modify air fuel mixtures to match the load.
The sensor receives a reference voltage from the computer and ground. Depending on the type of MAP sensor, it can alter the returning voltage or generate a digital square wave back to the computer.
You can test a MAP sensor for correct barometric pressure readings with a digital multimeter. This is a typical chart of voltage values for a GM sensor, based on the altitude at your testing location.
You can also test the MAP while it is running. Connect a vacuum gauge to the intake manifold and compare the reading on the gauge to the voltage reading you get from the MAP sensor.
A P0106 code means the computer has detected a value that is outside acceptable limits.
Problems that can cause the MAP sensor signal to be outside the specified range:
– Leaking EGR valve
– Vacuum leaks
– Dirty fuel injectors
– Wrong fuel pressure
– Low engine compression
– Ignition miss
– Carbon deposits on the intake valves
– Valve problems
Don’t expect the MAP sensor signal to be normal if the engine has a problem that causes low manifold vacuum.
© 2012 Rick Muscoplat
Posted on by Rick Muscoplat