Remove stuck oil filter yourself
Everyday I see DIYers post a question asking the best way to remove stuck oil filter. And just as often I see people who have driven a screwdriver into the oil filter can and tried to twist it. This is absolutely the WORST way to try and remove stuck oil filter. First, by driving the screwdriver into the can, you weaken it. Then as you try to turn it you simply tear off the can. All the filter media will tear off and you’ll be left with the thick metal plate that’s torqued against the oil pump flange. The only way to remove that plate is to get a sharp cold chisel and hammer a slot into the outer edge and try to spin it off. Chances are you won’t have a lot of working room and you’ll succeed in turning a relatively minor problem into a freaking nightmare.
How does an oil filter get stuck
If you read the directions on the oil filter it usually tells you to coat the O-ring gasket with oil and then spin it on until it bottoms, then turn an additional ¾ of a turn by hand. But people think that more is better and they crank the hell out of it. That compresses the square cut O-ring too much, making removal much harder.
Here’s how to remove stuck oil filter
If you’re using a band style wrench and it isn’t working, STOP. You need a different tool. If you continue using a band style wrench, you’ll simply collapse the can. And, if a cup style wrench isn’t working, it’ll just strip out the flutes. Some companies make a jaw wrench and brag that it’ll remove any filter. Don’t believe it. All they do is tear up the can. Same thing happens with a large slip-joint pliers
If you have a band style wrench: Go to the hardware store and buy a small package of 80 grit sandpaper with an adhesive backing. Cut into strips that are the width of the band. Clean the inside surface of the band and mount the sandpaper inside the band so the grit is facing the filter. Then try again.
Or, buy a band style filter wrench with permanent grit on the inside surface so you’ll never face this issue again.
Remove stuck oil filter with a clamp style filter wrench
Or, you can buy a clamping oil filter wrench that tightens against the fluted end of the filter. The harder you turn the more it grips.
I’ve used both of these tools and they HAVE NEVER FAILED. I’ve never run into a filter that wouldn’t come off.
Here are the wrenches I’m talking about:
Lisle tools 63600 ratcheting oil filter wrench. Fits filters from 3-1/3″ to 3-7/8″
Lisle tools 63250 oil filter wrench fits small import oil filters from 2-1/2″ to 3-1/8″
Lisle tools 63250 ratcheting oil filter wrench. Fits small import oil filters from 2-1/2″ to 3-1/8″
Band style with permanent grit Band style with permanent grit Band style with permanent grit Band style with permanent grit
©, 2015 Rick MuscoplatPosted on by Rick Muscoplat
- band style
- band style with permanent
- band style with permanent grit
- band style wrench
- filter wrench
- fits small import oil filters
- grit band style
- grit band style with permanent
- import oil filters from 2-1/2
- oil filter
- oil filter wrench
- permanent grit band
- permanent grit band style
- ratcheting oil filter wrench
- remove stuck oil
- remove stuck oil filter
- stuck oil
- stuck oil filter
- style with permanent grit
- style with permanent grit band