Regal tire pressure sensor reset

If you own a Buick Regal and need to do a tire pressure sensor reset, follow these instructions

1998

Repair or refill the tire and press the  reset switch in the fuse block. The indicator will flash 3 times and turn off the signal for the LOW TIRE indicator.

1999

Repair or refill the tire and press the  reset switch in the fuse block. The system will enter into e Autolearn mode. Drive the vehicle for at least 30-mins.

2000

Repair or refill the tire

Turn the ignition switch to RUN.

Then press and hold the RESET button located inside the instrument panel fuse block for about five seconds. The LOW TIRE light will come on and flash three times and then it will turn off.

Drive the vehicle for 15-20-mins. between 15-40, 40-65, and above 65 mph. The system completes the calibration process during driving.

2001

Repair or refill the tire

Turn ON the ignition, with the engine OFF.

Press and hold the red RESET button located in the passenger side instrument panel fuse block.

The LOW TIRE indicator will flash 3 times, then turn off.

 2002

Repair or refill the tire

Turn ON the ignition, with the engine off.

Press and hold the red RESET button located in the passenger side instrument panel fuse block.

The LOW TIRE indicator will flash 3 times, then turn off.

©, 2013 Rick Muscoplat