Nissan Maxima Mixture Ratio Self-Learning Control Procedure

Nissan Maxima Mixture Ratio Self-Learning Control Procedure

The Nissan Maxima Mixture Ratio Self-Learning Control Procedure is required if you replace an air/fuel ratio (commonly referred to as an oxygen sensor), Mass Airflow (MAF) sensor. The procedure applies to the Nissan Maxima vehicles listed below

1998 Nissan Maxima
1999 Nissan Maxima
2000 Nissan Maxima
2001 Nissan Maxima
2002 Nissan Maxima
2003 Nissan Maxima
2004 Nissan Maxima
2005 Nissan Maxima
2006 Nissan Maxima
2007 Nissan Maxima
2008 Nissan Maxima
2009 Nissan Maxima
2010 Nissan Maxima
2011 Nissan Maxima
2012 Nissan Maxima

Nissan Maxima Mixture Ratio Self-Learning Control Step-by-Step Procedure

1 Start the engine and let it warm it up to normal operating temperature.
2 Turn off the engine and move the key to the OFF position.
3 Disconnect the MAF connector. Then restart the engine and let it run engine for at least 3 seconds at idle speed.
4 Turn off the engine and move the key to the OFF position. Reconnect the MAF connector.
5 Restart the engine. The check engine light should be on and P0102 code should be stored in the ECM.
6 Using your scan tool or code reader, erase the P0102 trouble code. If you don’t have a scan tool or code reader, turn off the engine and move the key to the OFF position. Then disconnect the battery terminals and touch them together for 2-minutes. This will wipe out the stored code and all adaptive memory.
7 Restart the engine make sure the check engine light is out. Continue running the engine (don not drive it) at idle speed for at least 10 minutes.

©, 2020 Rick Muscoplat