2010 Civic Fuse Box Diagram: Exploring the Fuse Boxes

2010 Civic Fuse Box Diagram: Find the correct fuse for the circuit

This 2010 Civic Fuse Box Diagram shows two primary fuse boxes: the underhood fuse panel located in the engine bay next to the brake master cylinder and next to the driver’s side fender, and the Passenger Compartment Fuse Fuse Panel located under the steering column.Here’s what you need to know about each of them.

Find the most commonly requested fuses here:

In the UnderHood Fuse Box:

#4 40A Power Window Main
#7 20A Main Fan Motor Radiator Fan
#8 30A Rear Defogger
#12 15A Stop lights and Horn
#23 10A Backup lights

In the Passenger Compartment Fuse Box

#2 15A Fuel Pump
#5 15A Heated Seat
#12 10A Right High Beam Headlight
#13 10A Left High Beam Headlight
#16 10A Right Low Beam Headlight
#17 10A Left Low Beam Headlight
#28 15A Rear Power Socket
#29 15A Front Power Socket

NOTE About the Auto UP/Down Window Feature: If you remove the driver’s power window fuse, the AUTO function of the driver’s window will be disabled. To re-enable the AUTO feature, follow this reset procedure:

1) Start the engine. Push down and hold the driver’s window switch until the window is fully open.
2) Pull and hold the driver’s window switch to close the window completely, then hold the switch for about 2 seconds. If the power windows do not operate properly after resetting, have your vehicle checked by your dealer.

NOTE About the Radio: If the radio fuse is removed or you change the car battery, the audio system will disable itself. The next time you turn on the radio you will see ‘‘ENTER CODE’’ in the frequency display.

To make it work again, you must enter a specific digit code using the preset buttons (icon on vehicle’s with navigation system). Because there
are hundreds of number combinations possible from specific digits, making the system work without knowing the exact code is nearly impossible. Find the code on a card in your glove box or by entering your vehicle information on the Honda Website

Once you have the code, use the preset buttons (icons on vehicles with navigation system) to enter the code. If you make a mistake entering the code, do not start over; complete the sequence, then enter the correct code. You have 10 tries to enter the correct code. If you are unsuccessful in 10 attempts, you must then leave the system on for 1 hour before trying again.

2010 Civic Fuse Box Diagram for the Underhood Fuse Box

2010 Civic Fuse Box Diagram for the Passenger Compartment Fuse Box