Superheat load test on expansion valve system
You’ll need a digital readout thermometer and a temperature probe to perform a maximum heat load test on thermostatic expansion valve system. One inexpensive option is the AGPtek Dual Two Channel Digital Thermometer 2 K-Type Thermocouple Sensor.
and a PYLE Meters PCTL01 Pipe Clamp Temperature Lead.
With these thermometers, you can check the level of refrigeration charge, the operation of the evaporator and condenser, as well as and restrictions in hoses. Hey, if you want to save the cost of a shop conducting these tests, you simply have to own or have access to the right tools, so stop whining. There’s no cheap magic bullet to fix your car’s air conditioning system.
Set up the heat load test
1) Park the vehicle outside in direct sunlight
2) Open all doors and windows
3) Start and run the engine up to full operating temperature
4) Let the engine run at idle
5) Set AC to MAX
6) Set the blower on High
Click on the PDF below to open it
Start with the condenser temperature test
Clamp your temperature probe on the inlet A and outlet B tubes on the condenser coil. This test determines how much heat is being removed by the condenser. The condenser coil must remove at least 20° and no more than 50°F. Subtract the outlet B reading from the inlet A reading.
If the reading is less than 20°F here are the possible causes:
Poor airflow across the condenser coil.
Debris clogging the coil fins. Clean the condenser coil.
Improper airflow across condenser. Check for proper condenser fan operation (if electric) or fan clutch operation if mechanical radiator fan is used.
Check for broken or missing fan shrouds or seals
The system is overcharged
If the reading is more than 50°F here are the possible causes:
There’s air in the system. Evacuate and pull a vacuum for at least 45-mins.
The system is low on charge.
Restriction in condenser coil—sludge, too much oil, mechanical restriction due to pinched tube
Then conduct an evaporator temperature test
Clamp your temperature probe onto the suction line before the TMX valve at D. Measure the temperature of the suction line and compare it to the air temperature coming out of the center duct at C.
The temperature difference between D and C should be no more than 10°F
If the center duct temperature more than 10° warmer than the temperature of the suction line:
The system is low on refrigerant—All refrigerant boils at the bottom of the evaporator and the gas gains superheat
The refrigerant flow is restricted—bad of clogged TMX valve
The heater control valve is leaking or blend air door is open and heating the air after the evaporator coil.
If the center duct temperature is more than 10° COLDER than the suction line here are the possible causes:
System is overcharged
Finally, conduct a duct versus ambient temperature test
Measure the ambient temperature 3-ft. in front of the grille. Do NOT use radio or TV temp readings. Next, measure the air temperature at the center duct.
A properly operating system must be capable of removing at least 30°F of heat from the ambient air under this maximum stress test. If the system passes the maximum stress test, you’ll get better results when driving with the windows closed.
©, 2013 Rick Muscoplat
Posted on by Rick Muscoplat