Rick's Free Auto Repair Advice

Bleed power steering with vacuum

How to Bleed power steering

If you’ve replaced a power steering hose, pump, or rack, you must perform a bleed power steering procedure. If you don’t bleed air out of the power steering system, you can damage the power steering pump. One method you’ll see online and in some instruction manuals is to start the engine and turn the steering wheel full left and full right. This is referred to as the “lock to lock” method. It is an old and very outdated method that should not be used on late model vehicles.

Don’t turn the steering lock to lock to bleed power steering

The power steering system is capable of generating up to 2,000-psi when the wheel is turned to full left or full right with the engine running. Leaving the wheel in full lock position for longer than 1-2 seconds can damage the power steering hoses, pump vanes and blow out seals in the power steering gear. Do NOT use this procedure. Instead, use the vacuum procedure listed below.

Bleed power steering with a vacuum pump

Once you’ve refilled the power steering pump reservoir, remove air pockets in the steering gear by turning the steering wheel full left and full right WITH THE ENGINE OFF! You’ll see air bubbles coming up into the reservoir and that a good sign. It confirms that the gear is pushing air out of the piston areas. Then move on to the vacuum bleeding procedure

Install vacuum adapter into power steering reservoir

Use a universal or vehicle specific reservoir adapter to apply vacuum to the power steering system. Then, using a handheld vacuum pump and catch bottle, apply 25-in Hg of vacuum to the system. Let the vacuum sit for a minimum of five minutes or until you no longer see bubbles. Slowly release the vacuum. Install the factory reservoir cap and start the engine. If you hear any whining when turning the steering wheel, repeat the procedure. If you still have air, start the engine and turn the wheel full left and full right but DO NOT hold the wheel and the end of travel. Repeat the vacuum procedure one last time.

bleed power steering

Power steering vacuum bleed adapters

Chrysler warns against using the lock to lock procedure

Chrysler has issued a technical service bulletin TSB #19-008-05 REV. A with explicit instructions on how to bleed power steering systems on most of its vehicles. The TSB warns that if air is not purged from the system, the power steering pump can be damaged.

Start by filling the reservoir to the proper level. Install the P.S. cap adapter (Miller tool # 9688) onto the pump reservoir. Use a hand vacuum pump and pull a 20-25-inch vacuum on the system. Hold the vacuum for a minimum of 3 minutes. Then recheck fluid level. If the fluid level is now lower, repeat the procedure. Continue to repeat until the fluid level stops falling after vacuum is released. Chrysler also warns NOT TO TURN THE STEERING WHEEL stop to stop is is customarily done in the auto repair industry.

Buy a Ford Power Steering Bleeder Adapter

Buy a GM Power Steering Air Bleeder Adapter

Buy a Chrylser Power Steering Air Bleeder Adapter

Buy a Mityvac Power Steering Air Bleeder Adapter kit

Buy a Mityvac MV8000 Automotive Test and Bleeding Kit

© 2012 Rick Muscoplat

Posted on by Rick Muscoplat

Categories




Custom Wordpress Website created by Wizzy Wig Web Design, Minneapolis MN